Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part JUNE's Ride of the Month Challenge!
  • May's Ride of the Month contest ended with a tie! Go to this thread to vote on the winner! VOTE HERE
1 - 8 of 8 Posts

·
Registered
Joined
·
272 Posts
Discussion Starter · #1 ·
Tried these guys:

http://www.siliconeintakes.com

But they have inventory issues.

Need a 3.25" 90 degree for the intake and 3.5" 45 degree from mass air to filter

Any suggestions would be appreciated.
 

·
Registered
Joined
·
272 Posts
Discussion Starter · #3 ·
Thanks, but they don't stock the sizes I need.

any other suggestions ?
 

·
Registered
Joined
·
1,552 Posts
I trimmed a stock 5.0 intake tube for the top elbow. Not the prettiest solution, but it works...

http://home.comcast.net/~stangg/vmf/intake2.jpg
 

·
Registered
Joined
·
272 Posts
Discussion Starter · #7 ·
yeah, I tried that also, but I went with a 70mm throttle body, so the stock hose won't fit. I need a 3.25" 90 there and 3.5" 45 to my filter
 

·
Registered
Joined
·
1,552 Posts
I have a 70 MM TB also, If I recall correctly, I cut off the end, the curved section is just slightly under 3-1/4 but stretched easily on to the throttle body.
 
1 - 8 of 8 Posts
Top