Joined
·
79 Posts
I am just testing, this new site seems ok.
New Forum
Join the discussion
Recommended Reading
-
enggine shuts off after reaching operating temp
Vintage Mustang ForumNeed help with my 65 mustang fsbk it has a 302 8000 miles on engine new demon carb / fuel pump, pentroneix distributor and coil car starts and run well but after it runs for a few minutes it just shuts off as if I turned the ignition off will attempt to start but wont until it fully cools...- 0
- 0
-
C4 to 4 Speed: Parts List
Vintage Mustang ForumI'm rounding the corner on ordering the final parts needed to stuff a top loader in my '67 and I wanted to get input on if I'm missing any parts. Yes, I've searched the forum for an actual TOPLOADER parts list and found nothing. Yes, I'm committing to a 4 speed over a T5. This car was...- 21
- 400
-
Target · updated
-
Electrical gremlins are out to get me I think.
Vintage Mustang ForumSo I did a little cleaning on the engine bay today. This included taking off oil pressure gauge line to oil pressure sending unit and cleaning it. Put it back on and now gauge does not read correctly. Car has new sending unit. Any ideas? I made sure fitting is snug against sending unit. I do...- 0
- 16
-
jperls · updated
-
Temperature gauge reads low - despite replacing everything (almost)!
Vintage Mustang ForumMy temperature gauge has read low for 30+ years (so has my fuel level gauge). About 5 years ago I installed a new solid state dash constant voltage regulator thinking that was it. It wasn't. I'm now I'm in the process of a major rebuilt of a bunch of things. Since I had the dash apart, I...- 5
- 118
-
Modernizing a Vintage Mustang's Suspension and Steering Recommendations?
Vintage Mustang ForumHello Everyone, I'm in the process of planning my next project which will be a 1967 or 1968 Mustang. I want to build a Hot Rod , modern engine, transmission, (400HP with 5 speed manual shift), disc brakes, air conditioning, etc.... I'm hoping you guys can steer me in the right direction as far...- 29
- 2K
-
lennyB · updated
Join now to ask and comment!