Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part JUNE's Ride of the Month Challenge!
  • May's Ride of the Month contest ended with a tie! Go to this thread to vote on the winner! VOTE HERE
1 - 5 of 5 Posts

·
Registered
Joined
·
1,443 Posts
If it's like the majority of the sheetmetal I've worked with and heard other people's experiences from, it will require some massaging (i.e. cutting, grinding, swearing) but should work just fine.
 

·
Registered
Joined
·
3,900 Posts
It doesn't look bad, but the raised area where the rubber bumpers rest looks a little wrong. It looks a whole lot easier to fix than the fabrication job I had to do to coupe parts on my fastback.

Joe
 

·
Registered
Joined
·
484 Posts
Finally, that is one part that I have been hoping they would reproduce before I started with that area! I was dreading modifying coupe trunk corners.
 
1 - 5 of 5 Posts
Top