Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part August's Ride of the Month Challenge!
1 - 1 of 1 Posts

6,044 Posts
Discussion Starter · #1 ·
I jsut finished a center section swap. I pulled the axles using a angled box end wrench. All in all it took a bit of time (an hour) but went smoothly. Today I went to reinstall the axles. I happened to be looking right at the axle hub when I realized that I spent probably 45 minutes too long the other day getting the axles out. Staring me right in the face was an access hold to get the axle retainers off. So, after spending 30 minutes working the other one back in, I had the second one in the car in under 5 minutes... *sigh*

I can't say I didnt learn anything today!!
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.