Not another 16" wheel question

1 - 1 of 1 Posts

Guest

Joined Jan 1, 1970

0 Posts

Discussion Starter • #1 • Jun 22, 2002

Just wondered if anyone has pictures of a vintage car with properly spaced (by the chart of course) 16" wheels from a '99 GT. I would like to see them before I purchase the spacers I need. I tried searching but never found this specific picture.

Thanks

1 - 1 of 1 Posts

Recommended Reading

66 rear drum brake woes. Cant get rear brakes to bite

Vintage Mustang Forum

On my 66 mustang, I did a CSRP power disc brake conversion. I'm ready to road test my new motor and trans (331 stroker and 4r70w trans) install. But I've got a concern. When I installed the csrp disc brake conversion, I power bleed the system (and I prebled the master cylinder) The pedal felt...
- 4
- 30
- cturboaddict · updated a moment ago
Doing my own alignment. Quick question.

Vintage Mustang Forum

So I'm finishing up my suspension refresh. I'm doing my own alignment and getting my initial specs. I'm using Huskinhano's excellent write up as my how to. Huskinhano measured the caster using a 40 degree sweep, the gauge I bought (Fastrack 91000) uses 15 degree caster (30 degree total)...
- 1
- 0
- O
  oldpaint · updated a moment ago
Securing car to chassis jig - setting proper dimensions

Vintage Mustang Forum

Ok, so totally new at this and will be building a chassis jig this summer so I can do bodywork. Just for reference, the car has been in the family since purchased new in 65. Never had any metal/bodywork, but it does have a lot of rust I’m trying to address. The plan is to put it on casters so I...
- 10
- 161
- S
  STMU · updated 15 m ago
1969 Mach 1 rear end binding

Vintage Mustang Forum

My 69 mach 1 R-code has a binding noise from rear end while turning at slow speeds. The car was in storage for about 8 yeard until I got it out this spring. It has and did have oil in it, but it is binding rather noticiably. Thanks 3:50 traction loc
- 1
- 16
- N
  notyepcars · updated 19 m ago
aftermarket plug wires for 289

Vintage Mustang Forum

Looking for some input on good aftermarket plug wires for a standard 289. Original exhaust, 2V. I know there are several brands out there. But looking for information on good reviews from members here. I have used marti auto works for two restos but want to get away from those. Any help...
- 5
- 127
- 69mach351W · updated 24 m ago