Nov. '99 Mustang monthly. Anyone have a copy?
1 - 5 of 5 Posts
Joined
·
110 Posts
This link will get you most any back issues directly from Mustang Monthly..
http://www.the-direct-source.com/Products.ASP?DEPT=15
I dont have that one but have ordered a few back copies myself and received them within a few days.
http://www.the-direct-source.com/Products.ASP?DEPT=15
I dont have that one but have ordered a few back copies myself and received them within a few days.
Joined
·
3,118 Posts
try this site
http://www.hammar.dyndns.org/magsrch.htm
http://www.hammar.dyndns.org/magsrch.htm
1 - 5 of 5 Posts
Join the discussion
Recommended Reading
-
66 rear drum brake woes. Cant get rear brakes to bite
Vintage Mustang ForumOn my 66 mustang, I did a CSRP power disc brake conversion. I'm ready to road test my new motor and trans (331 stroker and 4r70w trans) install. But I've got a concern. When I installed the csrp disc brake conversion, I power bleed the system (and I prebled the master cylinder) The pedal felt...- 20
- 106
-
cturboaddict · updated
-
65 Rear brake drum?
Vintage Mustang ForumLooks like I have 10 x 1 3/4 rear brakes. Can I put 10 x 2 brakes on it with just replacIng the drums? I would assume the backing plates are the same?- 2
- 25
-
66Ccode · updated
-
289 exhaust reccomendations
Vintage Mustang ForumIm looking at upgrading my 68 289 mustangs exhaust and was specifically looking at these 2 exhaust kits on cjponyparts https://www.cjponyparts.com/dual-exhaust-system-2-1-4-with-magnaflow-mufflers-mustang-289-302-with-tri-y-headers-1965-1970/p/EXK11BM/...- 2
- 0
-
Group buy on PCV valves
Vintage Mustang ForumNo it’s not a joke, if we can buy 6 or more we get 25% off. I have one on my daily driver and it fantastic and they have a 30 day warrantee don’t like it send it back.. Anyone interested I’m willing to do the leg work if I can get solid commitment.. http://mewagner.com/- 58
- 1K
-
66Ccode · updated
-
1966 Mustang misc cleaning questions. (1969 302).
Vintage Mustang ForumHello i have some misc cleaning questions and "what to dos". 1. I have taken apart the whole engine and working on cleaning all the parts. The heads i have were super dirty and i cleaned with some P360 scuffing pads (pics below). I managed to clean them pretty good on the bottoms but not sure...- 18
- 201
Join now to ask and comment!