Vintage Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
251 Posts
Discussion Starter #1
I purchased a Sanden conversion kit for my '66. The kit included a batch of various size o-rings. I've just finished installing the kit and will be checking for leaks tomorrow. After disconnecting the dryer, liquid and gas lines, I didn't see any o-rings on my old York compressor set up. I also replaced my expansion valve and again, no o-rings. What am I missing here?
 

·
Registered
Joined
·
1,377 Posts
I would put the o-rings in. I had a couple without them and I had leaks. I've since added o-rings to everything. I don't know if that is correct, just my experience. Also, check for leaks at the service valves. I had to tighten mine a little.
 
1 - 2 of 2 Posts
Top