Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!

1 - 2 of 2 Posts

·
Registered
Joined
·
1,158 Posts
Discussion Starter #1
Keep the original or change? When I redid my engine I took the PS pump off and pulled it apart and rebuilt it. I still have a small leak where the pump hooks in the Borgeson. I don't think the nipple seals completely. Not a big leak but a drop here and there. I looked at changing hoses but wouldn't that just give me the same end fitting?

Just throwing out some thoughts.
 

·
Registered
Joined
·
1,818 Posts
First get a big flare nut wrench and try to crank down on the fitting pretty hard. This old setup sometimes need a lot of force to fully tighten (per Chockostang).
 
1 - 2 of 2 Posts
Top