Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part September's Ride of the Month Challenge!
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have an outer wheel well and quarter panel skin I am trying to install on my 1969 mustang. It seems to be about 1.5 inches to long in the rear and about 1 in to wide to go back in. I have the quarter fitting up but can’t get the quarter and outer wheel well to fit together. If the outer wheel well is installed and clamped into place the quarter would have to be bowed a great deal to fit. The first picture is the quarter mounted and appears to fit right (not a body guy). The second photo shows the outer wheel well from inside the car when the flanges are lined up. I am thinking about cutting the wheel well long ways then install and tack weld together. Any help or ideas would be appreciated.
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top