Vintage Mustang Forums banner

Performance places

Jump to Latest Follow

1 - 2 of 2 Posts
G

·
Guest
Joined
·
0 Posts
Discussion Starter • #1 •
Anyone know of a good performance shop is Western Washington? Thanks

1972 Mach 1
 
D

·
Registered
Joined
·
3,179 Posts
#2 •
Years ago I used to get stuff at Service Center in Lynwood (on Aurora Blvd). Sad to say I've haven't been back there in at least ten years so I don't know if it's still there. They used to sell new and used speed parts.

Regards,

Dean T

Shikatta Ga Nai - "It cannot be helped"
 
1 - 2 of 2 Posts
Recommended Reading
Read More

  1. Just how good should my brakes be ?

    Vintage Mustang Forum
    65 Convertible disc/drum setup ,just had new dual reservoir m/c and booster installed , new rotors and calipers and lines ,new wheel cylinders and shoes on the back. Struggling with long peddle travel and soft stopping. Have bled several times and adjusted the rear brakes as much as my mechanic...

  2. 70' Mustang Power Steering Idler Arm; Which one?

    Vintage Mustang Forum
    Without getting into a ton of details all new/replacement stock steering/suspension components purchased thru "CJ" which i installed in 2017, New 2 PS control valves and pumps purchased at NPD until I had the correct amount of PS assist. Also I have the shelby drop. Some of you may recall...

  3. Perplexed with engine/ignition issues

    Vintage Mustang Forum
    65 D code 289 has new radiator, electric ignition and coil (pertronix) and new rotor and distributor cap, spark plugs and wires, and a remanufactured Autolite 4100. It cranks up on the first key turn cold without any gas needing to be pumped into carb. The engine needs rebuilding eventually as...

  5. I cut my losses and found a local shop to do my brakes after wayyyyyyyy to much failure.

    Vintage Mustang Forum
    I found out the last few days its really tuff to find a shop that will agree to work on a classic. When I was working on my brakes changing to new lines and wheel cylinders I decided to upgrade to the dual master cylinder and My troubles started. My master cylinder that I was sent did not work...

  6. 1966 Mustang 289 - perplexing starting issue after car gets hot

    Vintage Mustang Forum
    Looking for some help, thanks in advance. I am encountering a very interesting issue. I have a new battery, voltage regulator, solenoid, battery terminal ends; and the problem persists. Car will start and run fine and I take it out and get it to operating temps. Then when I get home and turn...
Read More
About this Discussion
1 Reply
1 Participant
Last post:
Dean_T
Vintage Mustang Forums
A forum community dedicated to vintage Ford Mustang owners and enthusiasts. Come join the discussion about restoration, modifications, NOS parts, troubleshooting, VIN codes, and more!
Full Forum Listing
Explore Our Forums
Vintage Mustang Forum General Discussion (Non-Vintage Mustang) Mod and Custom Forum Classic Mustang Wanted Ads Concours Forum
Popular Communities
Community avatar for Home Entertainment
Home Entertainment
1,280,000+ members
Join
Community avatar for Mountain Bike Reviews
Mountain Bike Reviews
450,000+ members
Join
Community avatar for Working From Home Forum - New!
Working From Home Forum - New!
25+ members
Join
Top