Vintage Mustang Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
111 Posts
Discussion Starter #1
Hey all. One of my projects this winter is a new set of rims and tires. Currently I have the Cragar Unilugs and they are beat to crap. I have been looking around and doing some research and have maybe a dumb question. I see a set of rims on my local Facebook Marketplace from a Nissan that are 5x114.3. Assuming the backspace and tire size fit my car could I use these? Sac-religious as it may be these could conceivably go on I assume.

I am not planning on doing it as I have my eye on some torq-thrusts, I just wanted to know. Thanks!!!
 

·
Premium Member
Joined
·
13,155 Posts
In addition to the correct bolt pattern which is 5x4.5" or 5x114.3mm a wheel must have a center hole that is large enough to fit over the front hub and rear axle nub. I think most modern wheels have a fairly large center hole.
 

·
Registered
Joined
·
111 Posts
Discussion Starter #3
That’s a good point. Thanks for that.
 
1 - 3 of 3 Posts
Top