Vintage Mustang Forums banner

Plasma Cutters are Uhh-gly Machines!

839 Views 9 Replies 5 Participants Last post by  Guest
I tried a nice Plasma Cutter at welding class tonight, and it is very nice for cutting metal. For sheet metal, even at lowest settings, it is quite a bit of overkill. I could only get 1/8" wide cut, and ragged at that (lack of practice). I think a nice $200 air compressed die grinder would do much better than $1000 plasma cutter for working on cars. JMHO.

Getting much better at sheet metal welding. I welded up those nasty plasma cutter cuts as a butt joint. The instructor said if I could do that (and I was), then a nice, straight butt joint would be a piece of cake. Woohoo! Rusty frame rails: here I come! me check your shorts! My multimeter is just a-waiting! Formerly known as Midlife in the old VMF.
King of the Old Farts *struts*
1 - 1 of 10 Posts
Part of the frame on my gas grill has rusted away. I'll make burgers if you'll put it right.

J. Boggs

N0.. how bout steak then?
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.