Post deleted by bob
1 - 7 of 7 Posts
Joined
·
407 Posts
Congrats. If it takes 100 then I should be right behind you.
Joined
·
407 Posts
I'm there dude.
G
Guest
·Guest
Joined
·
0 Posts
Just made it there today too!
Joined
·
6,070 Posts
I made it to *Tire Kicker* then got bumped down to beginner again..now I am a *Wrench Turner*..but for how long?, is anyones guess.. *LOL*..lets just call it forum fate
'59 T-Bird..[color:blue]'70 Mustang Convert</font color=blue>...[color:green]'72 Mach One</font color=green>
http://www.geocities.com/theadgroup/t-bird.jpg
The Black Beauty, The old lady in my stable
'59 T-Bird..[color:blue]'70 Mustang Convert</font color=blue>...[color:green]'72 Mach One</font color=green>
http://www.geocities.com/theadgroup/t-bird.jpg
The Black Beauty, The old lady in my stable
1 - 7 of 7 Posts
Join the discussion
Recommended Reading
-
Engine Bay Paint
Vintage Mustang ForumI bought a couple cans of semi-gloss black for the engine bay. Semi-gloss black is getting hard to find. Now Im second guessing myself and thinking that the semi-gloss has to much gloss. I painted the dash with Krylon Satin Black and it turned out really nice. So now Im thinking the Satin...- 9
- 164
-
bmcgc · updated
-
Just how good should my brakes be ?
Vintage Mustang Forum65 Convertible disc/drum setup ,just had new dual reservoir m/c and booster installed , new rotors and calipers and lines ,new wheel cylinders and shoes on the back. Struggling with long peddle travel and soft stopping. Have bled several times and adjusted the rear brakes as much as my mechanic...- 72
- 2K
-
rtate · updated
-
Tips for Starting an Engine That’s Been Sitting
Vintage Mustang ForumCar has been sitting in my garage for the last 20 years and has not been started. I‘m replacing the fuel system and would appreciate some advice and tips on prepping the engine before firing it back to life. My Best To All- 10
- 146
-
Thegundog · updated
-
How Much Transmission Cooler is needed?
Vintage Mustang ForumMy car has a TCI C4 with a PA deep, finned pan. I have a PTC Race converter. It seems to flash to around 4k RPM. I've not yet done a brake stand. But without question it's probably putting out more heat than stock. I do have a trans temp gauge but it's not working and I have yet to figure out...- 4
- 209
-
jdub · updated
-
Fender ID
Vintage Mustang ForumI have a 6cyl Ford Mustang convertible assembled at Dearborn MI in February 1965. The Left fender is stamped with a triangle and 2 01 D3 on top. The Right fender is stamped 6330 D? on the top and in two sections towards the rear stamped 5 27 2D and 5 27 D2? Would these be original factory...- 0
- 40
-
Mike Tyne · updated
Join now to ask and comment!