Post deleted by bob
Join the discussion
Recommended Reading
-
Front bench seat upholstery
Vintage Mustang ForumGetting ready to recover my 67 bench. For those that have done this which brand of upholstery did you buy? Are you happy with it? If you had it to do over would you have done something different? Thanks for the help- 8
- 198
-
Danny Tietz · updated
-
Don't be like me...
Vintage Mustang ForumSo I have recently been working a lot. I am a PA working in then Army and I am in a 18 month program to specialize in Emergency Medicine. This past month I have been working 12 hour days 6 days a week plus extra time spent on research project, and didactic training. Anyway the past week has been...- 7
- 164
-
Sway bar wont fit lowered 67 coupe *pics
Vintage Mustang ForumSo i decided it would be a good idea to cut a coil out of my new scott drake springs. I think i cut too much... the spring basically falls out of the car now, absolutely no need for a coil spring compressor. While my car was on the lift the springs just bounced around, wasn't until i attached...- 11
- 288
-
Really struggling with brakes, drum rear, disc front
Vintage Mustang ForumTrying to get to first drive and I am now down to brakes. Right now car is on jack stands in the rear with an open diff, stock converter in the trans. When I put the car in gear at idle of course the passenger side wheel turns. I cannot get the wheels to stop with strong effort on the brake...- 10
- 161
-
Tallguy · updated
-
Electronic problems
Vintage Mustang ForumHello everyone: I've got a 67 fastback with a 289 4bbl and 4speed toploader. I've got a tribute tachometer in place of the am/temp guage that was working at one point along will all other electronics. One day the tach quit along with the turn signals, fuel gauge, temp gauge, heater fan and...- 6
- 351
Join now to ask and comment!