Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part September's Ride of the Month Challenge!
1 - 4 of 4 Posts

·
Registered
Joined
·
2,944 Posts
Kevin, You should probably check out the control valve and ram cylinder before you order. I ordered all my rebuild kits and then found that they were both garbage. If they have been off the car for a while, more than likely they're no good. My control valve spool was rusted to the inside of the housing and I had to use the BFH to get it out. After pricing the new valve and ram I decided to dump the power steering and go to manual. Just those 2 pieces were almost 3 times the cost of a manual drag link and left side tie rod ends.
 
1 - 4 of 4 Posts
Top