G
Guest
·Guest
Joined
·
0 Posts
Who can rebuild a power brake booster for a 1965 Stang? Also, where can I buy the single master cylinder for same?
POWER BRAKE BOOSTER AND MASTER CYLINDER
1 - 3 of 3 Posts
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Too hot to work on the Mustang, so I improvised.
Vintage Mustang ForumIt’s about 100 degrees here in sunny North Texas. Feels even hotter. We’ve got too much to do on my daughter’s car, so it’s time to get creative. I would have gotten a single larger unit, but my in-laws had these two 5,000btu units new in the box, so I’m giving them a test drive. After an hour...- 50
- 2K
-
BlakeTX · updated
-
Got my T5!
Vintage Mustang ForumWell after lots of searching, want adds, bartering, "horse trading" I finally have a T5 to put in my car. I'm into it for $150 CAD ($110 USD) From all the research I did this will work fine for my "stockish" Sunday driver car. 1968 mustang 289, 3 speed. I will use my existing clutch and...- 50
- 827
-
Stangfire · updated
-
Carb problems Rebuild or New ?
Vintage Mustang ForumSo I have a 289,30 over ,line bored and decked, hypereutectic pistons, hi-po heads ported and polished with 1.835 intake and 1.540 ex valves, port matched for both intake and exhaust with polished hipo exhaust manifolds 2 1/2 inch exhaust. Weiland stealth intake with this cam ...- 31
- 502
-
rtate · updated
-
Carb issue (maybe?)
Vintage Mustang ForumHello there, My 66 289 2bbl has become hard to start. Tried starter fluid but no help. Once it does start, it will idle rough for a minute and then just shut down. In looking at the carb, I noticed the plate is always open and has a range of just about an inch. (See pic, that is as closed as it...- 3
- 130
-
Installing FPA long tube headers and engine question
Vintage Mustang ForumI am almost ready to install my 351w, it's attached to an AOD. I plan to jack up the rear of the car and install the combo using a MAC's engine pivot plate. I've got some dense foam packing I'll tape in the engine bay to help avoid scratches but I am really hoping the pivot plate will give me...- 2
- 35
-
mikec35 · updated
Join now to ask and comment!