G
Guest
·Guest
Joined
·
0 Posts
what are all the parts to power brakes?
power brakes
Join the discussion
Recommended Reading
-
Turn signal grief
Vintage Mustang ForumJust finished replacing my turn signal switch for the third time— I go to test out the blinker, and it starts smoking. Doesn’t work at all now. 90 dollars and three switches later, I’m getting REALLY TIRED of these [email protected] things... After the second one blew out, I did some extra research. People...- 17
- 418
-
alex1965 · updated
-
66 Hipo spun rod bearing
Vintage Mustang ForumHi all, I need some advice. I bought a 1966 k code gt recently and drove it 1200 miles home with the only issue being a bad set of points. I then have the first weekend home with it and I hear a loud clunking sound. I diagnosed it to a spun rod bearing. I dropped the oil pan and the number 5...- 62
- 3K
-
Inaccurate fuel gauge
Vintage Mustang ForumI am chasing an inaccurate fuel gauge issue. A couple of years ago I bought this kit from CJ Pony: fuel-tank-kit-premium-with-drain-plug-1965-1967 which comes with this sending unit: scott-drake-fuel-tank-sending-unit-3-8in-with-brass-float-1965-1968. I tested the new sending unit and it read...- 39
- 15K
-
Dx2ry · updated
-
68’ Differential Housing Question
Vintage Mustang Forum8” Rear on this 68 Coupe and I was wondering if this front part of the carrier where the pinion is (smaller one with 3 bolts showing in photo) Has it’s own gasket underneath and can unbolt without taking the entire carrier and axles out. It appears it’s starting to seep a tiny bit now that...- 6
- 194
-
jsbenami · updated
-
Correct C4 transmission pan and gasket
Vintage Mustang ForumFolks, I have a 66 convertible Mustang, 2V, drum brakes And C4 trans. When I got the car the original transmission pan was beat to hell. I ordered a steel pan and gasket on line and when the pan and gasket arrived I tried to instal only to find out that the one bolt hole right to the right of...- 1
- 58
Join now to ask and comment!