Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part August's Ride of the Month Challenge!
1 - 2 of 2 Posts

·
Registered
Joined
·
625 Posts
I see the tri fecta of problems there. It appears you have washers shimming your starter out apparently because it is engaging improperly. So lets begin... washers shimming starter out, ring gear teeth getting ground on, and probably the starter Bendix the part that moves and engages the flywheel has shredded and left some of itself in the bellhousing. There is a manual and an automatic starter with longer or shorter nose cones this will allow different engagement start there and dont pass go,until you clean that mess up... Good Luck!
 
1 - 2 of 2 Posts
Top