Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part JUNE's Ride of the Month Challenge!
  • May's Ride of the Month contest ended with a tie! Go to this thread to vote on the winner! VOTE HERE
1 - 6 of 6 Posts

·
Registered
Joined
·
1,067 Posts
Discussion Starter · #1 ·
I did a search but haven't found the link I thought I had saved a while back. It seems that I had read a thread on how to cut out the quarter by laying the replacement panel on there and cutting both at the same time, then using clips to hold them in place while butt welding. I am a little ways out for this project but I like to think about it for awhile.

does anyone recall a good step by step guide that a member has posted that I can check out?
Thanks!
 

·
Registered
Joined
·
482 Posts
Check out the tech articles on the Mustang Monthly website.
 

·
Registered
Joined
·
1,067 Posts
Discussion Starter · #4 ·
Yes! thats the one, thank you very much!
 

·
Registered
Joined
·
2,169 Posts
Try this one too:
Link
 

·
Registered
Joined
·
1,067 Posts
Discussion Starter · #6 ·
Progress being made on my quarter panel replacements Cut and tack weldedhttp://i62.photobucket.com/albums/h115/bigcedarfarm/quartertackedon2.jpg http://i62.photobucket.com/albums/h115/bigcedarfarm/quartertackedon.jpg The finished product with a little more filler primer and sanding http://i62.photobucket.com/albums/h115/bigcedarfarm/quartertackedonfinished.jpg
Now for the other side http://i62.photobucket.com/albums/h115/bigcedarfarm/leftquarterbefore.jpg
 
1 - 6 of 6 Posts
Top