Question for Southern NH Folks...
Join the discussion
Recommended Reading
-
Front sway bar question
Vintage Mustang ForumI have a 1 inch front sway bar on my 66. The bolt on the lower control arm that goes through the sway bar and the sway bar are not at a 90 degree angle to each other. This is causing it to want to push the rubber insulators out. I did use the Ford style insulators, Not the hard ones that came...- 6
- 81
-
Transmission fitment
Vintage Mustang ForumWould a tremec 5 speed out of a 2000 Ford Mustang 4.0 liter V6, fit onto a 302 out of an 86? And as a general question, would any t5 fit a 302 ? So I can keep my eyes peeled for transmissions for sale.- 1
- 0
-
Rod77 · updated
-
Family abandoned 67' what to do
Vintage Mustang ForumHello all I'm new to this forum but not to cars or mustangs. I have quite a few. I near completion of my 74 Maverick Grabber and recently a Mustang I gave a family member has been given back to me. I owed her money so in return I gave her the car in 2009 or so. Shortly after it started...- 158
- 6K
-
Bad74maverick · updated
-
Spindle Identification Assistance
Vintage Mustang ForumHi All, I was wondering if anyone could help identify/confirm if these are stock Mustang spindles or are they aftermarket? I'm getting ready to order a new brake kit and need to know if it's a stock mustang spindle. Thank you in advance!- 7
- 48
-
Camshaft choice 390GT FE
Vintage Mustang ForumHi Guys I know its a common discussion but after all my research still cant decide. Its for a a very mild 67 GT mustang fastback, edelbrock performer plus intake, FPA headers into 2.5" magnaflow exhaust, petronix ignition, 600 or 650 Holley vac seconds, stock GT heads, harland sharp rockers...- 50
- 6K
Join now to ask and comment!