G
Guest
·Guest
Joined
·
0 Posts
Would like to know what the rpm rating is on a manifold marked "shelby" with part number SFJK-84240
question on 65-66 shelby manifold rpm
Join the discussion
Recommended Reading
-
Valve terrain geometry and push rod length.
Vintage Mustang ForumI’m going through the process currently. I’m using this video as the procedure. I have basically a stock 289. Cam information is below. I’m changing to Pro Comp roller tip rockers. My first issue is which push rod length checker do I need. I need a base line. I know stock push rods are...- 29
- 602
-
Stangfire · updated
-
1967 stone guard supports?
Vintage Mustang ForumAnyone have a photo of the '67 stone guard supports installed? I can't find a drawing or representation anywhere.- 5
- 90
-
j persons · updated
-
GT-A paint Stencil
Vintage Mustang ForumHey guys I had some damage to my front fender recently and I’m trying to get it fixed, it did chip the paint where the white strip is running down the bottom of the fender right before the tire, I’m trying to figure out where I could get a stencil that says GT-A on it so I can repaint the area...- 10
- 127
-
Antman68stang · updated
-
State Farm Antique Car Insurance
Vintage Mustang ForumI am in the process of having my dad's 68 Fastback signed over to me and in order to tag it, it must have insurance which is where I began searching the site. It sounded as though State Farm actually had some good reviews on their accepted value insurance, so I called my agent excited to get a...- 89
- 3K
-
stang289 · updated
-
1966 Mustang wont move
Vintage Mustang ForumGood morning Everyone. I have a 1966 Mustang, 289 with a 4spd Toploader with a hurst shifter. No matter what gear i put it in, my car wont move.It shifts perfectly fine into all the gears. I pulled the transmission out twice, put in a brand new pilot bearing and realigned everything. It has...- 2
- 54
Join now to ask and comment!