Vintage Mustang Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
597 Posts
Discussion Starter #1
I seem to remember that there were a couple of people here who used one of the rear ports on the Weiand Stealth intake for the heater hose (it made for a very clean install)? If so, does anyone have a picture that shows which port they're using on the back?

Thanks!
 

·
Registered
Joined
·
1,546 Posts
Not as clear a picture as Joes, but we both used the same port. No noticeible heating issues using this setup.

http://mark.emdnet.com/images/P1010447.jpg
 

·
Registered
Joined
·
3,047 Posts
Not Steatlth but I will get one for next engine, because I need rear port due to HEI -type huge distributor blocking front port. Mine is 8006, a sort of high rise Action+.

Cooling issues, hmm, nothing except it pukes out almost a quart of coolant after longer stints (10 laps or so) at track.
 

·
Registered
Joined
·
597 Posts
Discussion Starter #7
Great picts, guys - thanks.

Warren - do you have a picture of the rear of your setup? I'd like to see how you did both the heater hose and the temp. sender back there ...
 
1 - 7 of 7 Posts
Top