Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part August's Ride of the Month Challenge!
1 - 1 of 1 Posts

·
Gone but never forgotten
Joined
·
25,239 Posts
Aluminum intakes don't get torqued down as much as iron ones ... like 67gt says, about 10-15 ft. lbs.

Toss the cork end gaskets for the intake and use a 1/4" bead of high temp silicone instead. It will detail it in the Edelbrock instructions if you care to read them /forums/images/icons/wink.gif.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top