Vintage Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
303 Posts
Discussion Starter #1
I am installing R model aluminum ¼ panels on my 66 fastback. Any suggestions on how to prep the bare aluminum panels. Prime, sand, ECT. Also should I paint them before I rivet them to the car or wait until they are on the car? The car is Wimbledon white.
Any help will be appreciated.

Bob Sobers
 

·
Registered
Joined
·
58 Posts
If you are going to Alum in direct contact with steel, you will have big problems, they can not touch. I would use a 2 part bonding adhesive like the OEs do to bond the two.
 
1 - 2 of 2 Posts
Top