G
Guest
·Guest
Joined
·
0 Posts
I appreciate your reply and think you are probably right. Oh, well, guess that's just one more thing I'll have to start looking for. Thanks, agian.
andy
andy
Racer X 76 - Thanks very much.
Join the discussion
Recommended Reading
-
Intake manifold options
Vintage Mustang ForumHI Situation : 66 HT 289 2100v stock. I have a 68 302 4BBL intake and newer 600 cfm Holley carb. Do I purchase an aluminum intake or use the old one? If I replace the intake which do you recommend. O- 14
- 365
-
oscarnielsen · updated
-
Brake booster question, which one?
Vintage Mustang ForumI was going to stay manual brakes but since my engine is out and I am adding borgeson steering I've decided to go with power brakes. Up front I have Wilwood discs and on the rear I have 2003 Cobra disc brakes mounted to Mustang Steve brackets. I also have a Wilwood adjustable proportioning...- 3
- 116
-
mikec35 · updated
-
First real outing with the 67’
Vintage Mustang ForumAfter what seemed like forever (since October lol) finally got things straight and was able to take her out for more than a 5 mile test ride. A little Picnic lunch by the Tred Avon River then a ride over to Oxford for some ice cream a ferry ride across the river and the long way home. Felt...- 15
- 267
-
jjpish68 · updated
-
Bleeding brakes. Frustrated, got to vent.
Vintage Mustang ForumSo I'm trying to bleed my brakes after replacing my master cylinder. I got a 65 6 cylinder with four wheel drums. I've gone around the car 5 times trying to get the brakes bled. I'm doing it with my wife doing the press, open, close, release method and got out all the big bubbles I could see...- 8
- 201
-
Rocker arms/ push rod removal
Vintage Mustang ForumHello, This is my first Ford inline 6, 200ci in a 1970 ford falcon. I have a question that will be simple for everybody here but I'm not afraid to look dumb and need some help. I am ready to remove the rocker arm assembly and push rods to move onto removing the head, but before I turn any bolts...- 8
- 142
-
70Falcon200 · updated
Join now to ask and comment!