Vintage Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
865 Posts
Discussion Starter #1
A non-mustang 8 inch diff was installed during the I6 to V8 conversion done by the PO. The problem I am having is trying to find a new flex brake hose to fit the existing hard lines. The distribution block on mine is mounted on the axle housing by the breather tube, no offset bracket.

No ID tag was on the center section when I bought the car. How can I ID this rearend to get the hose which fits?
 
G

·
Guest
Joined
·
0 Posts
Find some hot rod magazines/mail orderplaces and look a "generic" hoses. Typically, you can find hoses with any ends you want at any length custom ordered. Its not too expensive.

As an example:

http://www.speedwaymotors.com/eCCStoreFront/smi/product_images//Full/91031842.jpg


http://speedwaymotors.com
 
1 - 2 of 2 Posts
Top