Vintage Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
462 Posts
Discussion Starter #1
Hi all - I did a search, but couldn't find anything. I am stripping the K down to get it ready to go to media blast. Anyway, how does one go about removing the rear fold down seat? I have removed the seat bottom and most of the trim around it, but how do I remove the folding portion? Thanks.
 

·
Registered
Joined
·
2,288 Posts
Hello.The seat back should have two screws on the bottom edge.Remove them,pull the bottom of the seat out a little and lift upwards.Next the back section of the package shelf has to come out.It is held in by four screws,two of them are in the small chrome pieces towards the back and the the other two are towards the front straight into the carpet.Remove the screws,lift the front edge up a little and pull it forward to clear the two clips that are on the bottom side of it.You will then see the hinges.Take the four bolts out of the hinges and the remaining assembly will come out.Hope that helps. :)
 
1 - 2 of 2 Posts
Top