Vintage Mustang Forums banner
1 - 5 of 5 Posts

· Registered
Joined
·
596 Posts
Discussion Starter · #1 ·
I asked this question earlier this week and did not get a response so I'm trying again.

Besides the three small screws on the rear trim quarter panel there is a rather large opening at the top of the panel under the package tray. I think a bolt or some other type of fastner goes there. Does anyone know?
 

· Banned
Joined
·
4,173 Posts
Don't know what you mean by large opening? But I have a trim panel sitting in my garage, and at the top near the package tray is flat with a hole for a mounting screw. I can take a picture of it if you need one. Mine is not off of a GT, so I don't know if there is a difference.
 

· Registered
Joined
·
596 Posts
Discussion Starter · #3 ·
Yea i think we are talking about the same hole should be a little bigger then 1/4 inch circle. and there is also a matching hole under the package tray on the ledge....right? On mine there is. So do you know what type of fastener goes there. I dont think its a screw. Thanks for the help
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top