Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part JUNE's Ride of the Month Challenge!
  • May's Ride of the Month contest ended with a tie! Go to this thread to vote on the winner! VOTE HERE
1 - 2 of 2 Posts

·
Registered
Joined
·
639 Posts
Discussion Starter · #1 ·
'66 NJ coupe GT dual exhaust

Brake lines are all factory dual setup.

I installed the exhaust and I'm not sure how to route the rubber brake line hose from the hard line to the rear axle junction. It looks like it could go either to the front or to the rear of the pipe that goes over the axle.

Which side is correct, front or rear of the exhaust pipe? Should I mount the hose with a bit of a twist in it? that looks like it would help clear the pipe.

TIA
 
1 - 2 of 2 Posts
Top