Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part September's Ride of the Month Challenge!
1 - 1 of 1 Posts

·
Registered
Joined
·
60 Posts
Discussion Starter · #1 ·
On the sheet metal panel behind the rear window of a 66 fastback is there more than one company producing this part or is it just the one in Taiwan?Although the part looks good the area where the window sits is not at a 90 degree angle an the lip on the trunk area is not big enough.
 
1 - 1 of 1 Posts
Top