Vintage Mustang Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
105 Posts
Discussion Starter #1
67 coupe- need the remote mirror retaining nut washer.
Also, set of front seat belts that came with a bench seat car.
 

·
Registered
Joined
·
942 Posts
This is a good request/question about the bench seat seat belts.....I have seen very few REAL bench seat cars (I believe they use a "C" after the body code) (such as 76C)( for a '65-'66 convertible) I really don't know IF there was a separate seat belt for whomever would sit in the middle......anyone know???
 

·
Premium Member
Joined
·
4,935 Posts
If I can find belts, where do you mount them on a bench seat car? Tom
The belts mount to the trans tunnel and inner rocker, the same place
they do on a bucket seat car, in fact I believe they are the same belts.
I got a pair out of a 65 once that had a bench seat and I didn't see any
difference in them, seemed to be the same length.
 

·
Premium Member
Joined
·
4,935 Posts
This is a good request/question about the bench seat seat belts.....I have seen very few REAL bench seat cars (I believe they use a "C" after the body code) (such as 76C)( for a '65-'66 convertible) I really don't know IF there was a separate seat belt for whomever would sit in the middle......anyone know???
There wasn't a seperate belt for the middle area, don't believe Ford
considered it a area to sit in, the arm rest is the nice feature of it though.
 
1 - 8 of 8 Posts
Top