Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part MAY's Ride of the Month Challenge!

1 - 2 of 2 Posts

·
Registered
Joined
·
611 Posts
Discussion Starter · #1 ·
Is it possible to remove the master cylinder push rod in the car? The clutch thru bolt prevents the pedal from being used to pull it out.

I cannot removed the MC without pulling the engine. It’s a coyote swap.

The push rod is too tight on the pin (by about .05 or so) and my rear brakes are dragging slightly.

Thanks for the help.
 

·
Registered
Joined
·
611 Posts
Discussion Starter · #2 ·
ok, so a little googling and it looks like I can adjust the push rod from the booster into the MC. Working on that now...
 
1 - 2 of 2 Posts
Top