Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part JUNE's Ride of the Month Challenge!
  • May's Ride of the Month contest ended with a tie! Go to this thread to vote on the winner! VOTE HERE
1 - 3 of 3 Posts

·
Registered
Joined
·
82 Posts
Discussion Starter · #1 ·
Hello,

I have a 67 Mustang with the 6 cylinders 200. Had motor + head completely rebuilt about 10,000 miles ago. Now the head gasket is weeping coolant by cylinders # 3 and 4. It is a very small leak. No coolant in oil. Apparently this is fairly common? I would like to try and retorque the head gasket before I go for full replacement. Should I do it with the motor hot or cold? Also anybody know how much I should torque it to?

Thanks!
 
G

·
You can re check the torque but I doubt it will stop the weaping. FWIW my 200 weaped in the same spot. I would first talk to the engine rebuilder before I did anything including retorquing the head.
 
1 - 3 of 3 Posts
Top