Vintage Mustang Forums banner
1 - 14 of 14 Posts

·
Registered
1966 GT 4spd
Joined
·
1,460 Posts
Did these come off of your car?

Chris
 

·
Registered
1966 GT 4spd
Joined
·
1,460 Posts
Do you have any photos of them installed?

Thanks!

Chris
 

·
Registered
Joined
·
11 Posts
I can’t find sill plates on ringbrothers site. Is that a black pain on them? Im considering all ring bros trim myself. But never seen the plates and not sure if I like them. I have a 68 but I think it’s all interchangeable from my review of ring bros site. Can you confirm this? Where are you located?
 

·
Registered
Joined
·
142 Posts
Fit a standard non-convertible 1966 coupe?
 

·
Registered
Joined
·
15 Posts
Discussion Starter · #9 ·
I can’t find sill plates on ringbrothers site. Is that a black pain on them? Im considering all ring bros trim myself. But never seen the plates and not sure if I like them. I have a 68 but I think it’s all interchangeable from my review of ring bros site. Can you confirm this? Where are you located?
The part number was 7156 stamped on bottom like i said they have switch the design from this set..Also have the recpit that states ringbrother..
 

·
Registered
1966 Mustang Coupe 302 T5
Joined
·
132 Posts
Is that plate shorter than a normal one.
 
1 - 14 of 14 Posts
Top