Vintage Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
298 Posts
Discussion Starter #1
Installing the Edelbrock Performer Intake with Edelbrock Performer Heads on my 351W. I have noticed that the water passage on the intake and the head do not seam to match up well at all. It appears that the passage on the intake has excess material that blocks the passage. Should this be removed?

Have any of you noticed the same thing?
 

·
Registered
Joined
·
10,587 Posts
I ran/run this combination on the race car and, although I didn't notice any gross mis-match, there has been no adverse cooling effects to note. My parts are relatively early (ca 1995) so they may be different.
 
1 - 2 of 2 Posts
Top