Vintage Mustang Forums banner

1 - 2 of 2 Posts

·
Administrator
Joined
·
12,995 Posts
Discussion Starter #1
I am going to the salvage yard on Wed. and will be looking for seats for my 65 FB. I've measured the rails on the 65. Can I only use the width that is the same on other modern seats for the 65? Does that make sense? I just measured a friends RX7 seat rails and they were 17" wide. I take it that those won't fit my car? Any help out there would be appreciated.
Stan
 
G

·
Guest
Joined
·
0 Posts
You can make/modify anything to fit if you set your mind to it and spend enough on it! From past experience, if the rail width is the same the seats will install relatively easy.
 
1 - 2 of 2 Posts
Top