Vintage Mustang Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter #1
Exactly as the title says, I am looking for a metal template to do the Shelby drop on my 1967 Mustang. I figure someone has one. Hate to buy a new one to use it once.
 

·
Registered
Joined
·
4,259 Posts
On a '67-68 it's pretty easy as it's only down 1", no front to back offset. A short piece of 3" wide flat stock and you can make your own.
 

·
Premium Member
Joined
·
750 Posts
I have a metal template, used once by me on my 68, I don't need it any longer. If you want to pay shipping, I'll send it to you. Should be able to ship it for $8.
Ed
 

·
Just some guy
67 coupe, 69 Sportsroof, 86 hatchback
Joined
·
21,028 Posts
Have a look at the sticky in the "trade/free" section. I found that printing out a PDF to pin punch the hole locations was all I needed. But If you just prefer using a template there's a fella offering his on there. "Boxhead" I believe.
 
1 - 4 of 4 Posts
Top