Vintage Mustang Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,859 Posts
On the TCP website, on the page outlining the installation of their front end system, there is a good pattern(best one I've seen) that printed perfectly on my HP-6L
 

·
Registered
Joined
·
531 Posts
I searched and searched and couldn't find any that printed to scale. The drop seemed to be to scale (1"), but the UCR holes were always too narrow. I had to cut the template in half vertically and line the old holes in the template up to the new ones, then the new ones would almost fit (my repro UCR bolts were a little bit wider than the original and wouldn't even slide in the original holes).

Best of luck... If you find a worthy template, you may post the site so others can benefit....
 
1 - 5 of 5 Posts
Top