shelby rollbar?
Join the discussion
Recommended Reading
-
Mysterious Electrical Gremlins
Vintage Mustang ForumHi. So, I've been having intermittent engine cuts out, but would fire straight up again after. Recently it's been harder to start and keep running that I haven't dared drive anywhere. Have set timing, new distributor, plugs, leads and coil. Latest addition was electronic ignition and after...- 15
- 350
-
Need Chassis Measurement Please
Vintage Mustang ForumHi everyone, I'm getting ready to weld in my new front frame rails and the extensions. I was hoping several people could help me verify a dimension. As one could observe from the Liskey drawing above is that it seems like the front frame rail extension is in-line and parallel to the rear...- 5
- 127
-
7T02S · updated
-
Carb popping after Accel Install
Vintage Mustang ForumHey all, thanks for the help in advance. I installed the Accel points eliminator and a blaster solid coil with a full 12v going to it (bypassing resistor wire). I recently rebuilt my stock distributor and installed a new vacuum advance. The motor is a 289, mild cam, intake and headers and the...- 14
- 158
-
Desert66 · updated
-
Picking an engine?
Vintage Mustang ForumI would like to hear some opinions before I purchase or build an engine. I'm getting close to the point of an engine. I have a core for a 1976-302 or a 1984-351 not sure of which one I would like as my finished engine. I am not building a show car, but a nice muscle car to drive on weekends. I...- 15
- 539
-
7Dpilot · updated
-
More front spring craziness
Vintage Mustang ForumOn the 65 I put the 620's I had (for ever) which were for my 67 convertible build. Anyone remember Canadian Mustang? These are far too stiff and sit way high, even though they are 1 inch drop. And I know cutting these down isn't going to solve the super stiffness. Stock GT's are 291 and NPD has...- 16
- 447
-
ylexot · updated
Join now to ask and comment!