Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part MAY's Ride of the Month Challenge!

1 - 3 of 3 Posts

·
Registered
Joined
·
59 Posts
Discussion Starter · #1 ·
How do I remove the old shift lever seal from the shift lever bezel on a '65 automatic? Is it held on by rivets or what? I can't figure out how to get the old one off or how to install the replacement...
 

·
Registered
Joined
·
456 Posts
I pulled mine off the rivets. I used 2 small screws to retain the new one(after drilling 2 tiny pilot holes). That's a good question. I'd like to know myself.
 

·
Registered
Joined
·
2,046 Posts
Ditto. Your method sounds good though.
 
1 - 3 of 3 Posts
Top