Vintage Mustang Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
815 Posts
Discussion Starter · #1 ·
I just replaced my shock towers and before re-installing the suspension I want to reinforce them on the inside where they attach to the frame rail. Can anyone figure out the correct way to install the reinforcement piece?

See Pic HERE!


Is the metal bent on 90degree angle and welded or does it sit on an angle?
Thanks
 

·
Registered
Joined
·
815 Posts
Discussion Starter · #3 ·
"The reinforcement that I've seen is shaped to fit the contours of the tower at a 45* angle"
45*? So there would be space left in behind the piece? I'm confused - unless you meant 90*.
 

·
Registered
Joined
·
815 Posts
Discussion Starter · #5 ·
Do you have a pic of inside the tower? Thanks
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top