Vintage Mustang Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
202 Posts
The reinforcement that I've seen is shaped to fit the contours of the tower at a 45* angle. I've also seen rectangular peices welded to the flat area in the middle and to the frame rail only. I have seen (but I can't remember where) triangular peices welded in the corner created by the frame rail/shock tower/inner fender on the engine side. I'll probably be adding these as well as the pieces you are asking about.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top