Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!

1 - 2 of 2 Posts

7 Posts
Discussion Starter #1
Good Evening All,

I had the Heidts IFS installed and am currently rebuilding the engine compartment metal. I am going to call Heidts on Monday, but was wondering if anyone knew if the shock tower replacement metal was supposed to go on the inside or the outside? When I put it on the inside, it interferes with the stamping. When I put it on the outside, the holes don’t line up. Any thoughts? I plan to but weld them in eventually, but I’m trying to make sure I get the fitment so I can mark and cut.


Sent from my iPhone using Tapatalk
1 - 2 of 2 Posts