Get ahold of the factory "Body Parts" book. It shows all the mouldings and how they are attached. Ive got the 65 all ford product one and it's very informative. Just the Factory shop manuals are also good.
Get the real shop manual. It's exactly what you want. Then once
you have that, you can decide if there are any areas where you
need more detail. There are plenty of other books with more
detail in one area or another and folks here can suggest more
books to help you fill in the blanks.
'67 C-code 'vert (Dees67)
'69 GT FB (project car)
Check out my band: Brickyard Blues
Anybody running a shroud or panel under the radiator like modern cars? I recently took out a perfectly good radiator at an autocross due to a rock getting between the radiator and engine and bouncing into the radiator and taking out 4 rows when it bounced off the fan. Maybe it was a 1 in a...
Can anyone provide me with the dimensions of the windshield washer bag bracket that is found on early 1967 mustangs? I have had no luck in finding a used one and they aren't available repro.
This bracket is spot welded to the driver side inner fender apron.
Need help with my 65 mustang fsbk it has a 302 8000 miles on engine new demon carb / fuel pump, pentroneix
distributor and coil car starts and run well but after it runs for a few minutes
it just shuts off as if I turned the ignition off will attempt to start but wont until it fully cools...
I bought a 1965 vin# 5R07C147717 on title and door tag. Title shows it as 1964. WHY? Door tag is 65A J 26 14K 75 6 6. So it was produced On 14-OCT 1964 After July it should be 1965.
It does have some of the 64.5 features like spare tire hold down as a groove not a J hook type, Door handles...
Good morning everyone-
I am planning to add EFI to my car over the winter and am wondering if anyone has experience with the Pro Flo 4. The Holley Sniper is a popular option and I’ve been thinking a lot about it, but can’t help but wonder if it’s somewhat antiquated at this point. Edelbrock...