Vintage Mustang Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
So I had to cut off of the PW slave cylinder-to-center link nut on my '65 and ended up dinging the stud threads in the process...anyone know the size/thread of the stud so I can pick up a new bolt and also retap the stud?

Thanks!
 

·
Premium Member
Joined
·
11,777 Posts
That is not a bolt, it is a tapered stud just like a tie rod end or a ball joint. To the best of my knowledge they are all fine thread so 1/2"-20 or 9/16"-18 would be my guess.
 
1 - 6 of 6 Posts
Top