I started to install the rear brace set-up on the car, in the front I have a 1/4" gap side to side and in the rear I have a 5/8" gap side to side, do you have any spacers for this or can I just make up some square plates to take up the gaps? I also e-mailed the Tech Dept. also
Anthony in the tech department should be able to get it straightened out. I will be out of the office for a week or two due to a family emergency so my time around here will be very limited.
J, got the plates yesterday, perfect fix, now just to get that darn bushing in on the sway bar, that thing is tight, going to have to sand down the bushing on the outside and see if I can get it to go in the mount.
Is this for the rear suspension? got my front TCI all installed and it will be painted next week. Now I need to decide on a rear suspension. I also need to swap motor mounts and spindles
Craig
I sent Sal & the tech. department a e-mail this morning, I am missing some parts for the rear-end set up, could you please see that they got it?
Thanks Pat, it would let me attached it here.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Vintage Mustang Forums
4M posts
89.4K members
Since 2001
A forum community dedicated to vintage Ford Mustang owners and enthusiasts. Come join the discussion about restoration, modifications, NOS parts, troubleshooting, VIN codes, and more!