Vintage Mustang Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
2,240 Posts
Discussion Starter #1
My trunk is now new and I have the old sections and junk wire sitting here and I was going to put the hole in the side of the trunk floor / drop off for the wire that runs down to the sender, but I wanted to check and make sure that the 65 wires (my car is a 65) are available on the aftermarket that use that hole? I figured with my luck I would run into that 65 only issue again and end up with a 66 that may be totally different for all I know?

So do I just replace the hole and know that it's all good or should I consider another option?
 
1 - 1 of 1 Posts
Top