Vintage Mustang Forums banner

1 - 4 of 4 Posts

·
Registered
65 Mustang fastback, GT350 clone
Joined
·
21 Posts
Discussion Starter #1 (Edited)
SOLD!!

P/N TCP RCKM-02
This has been installed and has a few hundred miles. This is a picture from this week. Includes all hardware including tie rod ends, steering shafts and U-joints. I have the original installation instructions and there’s a nice video on YouTube. There is some cosmetic damage on the end of the drivers side of the body of the rack from improper clearance set up. Selling as I’m going with power steering. I seem to only be able to post one pic, but PM me and I can get you more.
Will ship at your cost. Can see near Chicago.
Originally $1685. Asking $700.
748976
 

·
Registered
65 Mustang fastback, GT350 clone
Joined
·
21 Posts
Discussion Starter #3
749550
749551
749552
749553

The rack is completely uninstalled, packed, and ready to ship. The photos show everything included. The cosmetic injury on the passenger side is shown. With the tie rod ends disconnected, full travel showed no interference so I’m assuming this happened with installation? The steering column takes a little work to install and I have a new one, so I’ll just give you the whole thing. It’s wired and has all parts installed. I’d replace the turn signal while you’re in there.
Let me know!
 
1 - 4 of 4 Posts
Top