Vintage Mustang Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
506 Posts
Discussion Starter #1
The PO installed what I recently found out was a Stainless Steel Disc Brake kit. I had a brake job done not too long ago and my Brake guy said the back side of the rotor was grooved so bad it couldn't be turned...bummer :p

He went ahead and replaced the pads so I'm gonna have to replace them soon...what do I replace them with? How do I know which rotors to order from a supplier? Will junkyard Granada rotors work? ::
 

·
Registered
Joined
·
506 Posts
Discussion Starter #3
Thanks Jay, sent em an e-mail, they have a set of drilled rotors and pads for $250, hoped to spend a bit less, I asked them if they had any other options...we'll see!

Thanks again!

Scott
 

·
Registered
Joined
·
16,014 Posts
Also see if you can get an instruction manual too. I don't know about SSBC, but Baer includes all the part numbers in their kit so you can find replacement parts at the local auto store (for most of the items).

Good Luck.
 

·
Registered
Joined
·
2,176 Posts
I have the SSBC kit, I used stock replacement rotors from JC Witney, they were 39.00 ea. What calipers does your kit have? That will tell you what pads to buy.
 
1 - 6 of 6 Posts
Top