Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part JUNE's Ride of the Month Challenge!
  • May's Ride of the Month contest ended with a tie! Go to this thread to vote on the winner! VOTE HERE
1 - 6 of 6 Posts

·
Registered
Joined
·
3,900 Posts
Discussion Starter · #1 ·
I have finally started to cut the 1/4 panels apart on my Boss 351. I am cutting them apart gradually to decide how much to replace. There is only minor rust, but the PO cut them up and flared them. I don't want to repace any more metal than necessary, so I'm slowly cutting them away until I get to a point that looks like a good place to start. It's about time I get off my lazy duff and get something done!

Joe
 

·
Registered
Joined
·
4,670 Posts
Why not just replace the whole skin? Wouldn't it make it a cleaner looking job?
 

·
Registered
Joined
·
3,900 Posts
Discussion Starter · #5 ·
I've had it for about 3 years, just haven't had time to start on it until now.

Joe
 

·
Registered
Joined
·
3,900 Posts
Discussion Starter · #6 ·
mod9 said:
Why not just replace the whole skin? Wouldn't it make it a cleaner looking job?
I don't want to disturb the factory spoy welds, the car is really clean.

Joe
 
1 - 6 of 6 Posts
Top